Home - LMT07 - LMTTX3020A

LMTTX3020A

Identify and correct weaving process faults

Unit Descriptor This unit covers the skills and knowledge required to identify and correct product and weaving loom faults.

ELEMENTPERFORMANCE CRITERIA
1 . Gather relevant information

  1. Pattern and production requirements are checked

  2. Weaving operator is consulted on loom operation and on any operator identified faults

  3. Loom operation and woven product is observed for faults

2 . Recognise and correct weaving faults

  1. Weft faults are identified

  2. Warp faults are identified

  3. Selvedge faults are identified

  4. General faults including incorrect creeling and other set up faults are identified

  5. Cause of fault is determined and action taken in accordance with OHS practices

  6. Any changes needed to be made in loom operation by the weaving operator are explained

3 . Maintain records

  1. Records are maintained and reports prepared, where necessary





Key CompetencyExamples of ApplicationPerformance
Level
How can information be collected, analysed and organised?
How are ideas and information communicated within this competency?
How are activities planned and organised?
How are problem solving skills applied?
How are mathematical ideas and techniques used?
How is use of technology applied?
How is team work used within this competency?

Range Statement

Legislative/regulatory requirements

All work must comply with relevant Federal and State or Territory legislative or regulatory requirements.

Looms may include

Weaving faults may include

Causes of faults may include

OHS practices

OHS practices must include hazard identification and control, risk assessment and implementation of risk reduction measures specific to the tasks described by this unit, and may include:


Evidence Guide

Critical aspects of evidence to be considered

Demonstrates skills and knowledge to:

Consistency in performance

Consistently applies skills and knowledge when:

Resource implications

Access is required to real or appropriately simulated situations, including work areas, materials and equipment, and to information on workplace practices and OHS practices.

Context for assessment

Assessment may occur on the job or in an appropriately simulated environment.

Interdependent Assessment

This unit should be assessed in conjunction with LMTTX3003B Set up and operate weaving looms for production